MPCCP-1 Cordless Chair Leaving Detection Sensor Pad with Alarm Pager

✓ Simple to use Chair leaving detection alarm requiring minimal installation
✓ Cordless sensor detects a person rising from or leaving their chair
✓ Wireless alarm transmission to included carer radio pager
✓ For single chair monitoring expandable to 3 chairs/beds

The MPCCP-1 is a reliable solution for detecting a person at risk from falls leaving their chair. The sensor has a zip seal pocket where the transmitter is concealed. The included pager has tone and vibration notification alert, accompanied by an active alarm channel LED. The pager can monitor up to 3 separate sensors, indicated by Sen1, Sen2, Sen3. The kit is suitable for domestic, residential, and hospital falls management.

Included in this Kit

1 x MPUCP10T Chair sensor with transmitter
1 x MP-PAG31 Carer alarm pager
All batteries included

Key Features

• Rapid detection and notification to chair leaving
• Silent alarm at chair with transmission to carer pager
• Simple to install, use, and maintain
• Durable hard wearing chair pressure sensor pad
• Antiallergenic PVC sensor materials
• Water resistant easy clean surfaces
• No cords or cables, inconspicuous during use
• Suitable for under or on top of the chair cushion
• Expandable up to 3 beds/chairs

Technical Features
Conductive sensor materials: Silver and Carbon paste
Dimensions: 38cm x 25.5cm
PVC thickness: 0.45mm
Non-conductive material thickness: 5mm
Total uncompressed thickness: 6.4mm
Operating temperature: 10C - 40C
Sensor pocket connector: Mini-USB female
USB mini female for transmitter connection
Module dimensions: 67 x 55 x 10mm
On/Off Switch for power
Bed/Chair sensor type switch
Operating Radio Frequency: 433MHz
Wireless operating range: 50-75M
Connection via mini-USB female socket (in pocket)
Low battery warning transmission

Technical Features MP-PAG31 Carer Pager
Power source: 2 x AA batteries
Receiver range: 100 metres
Radio frequency: 433MHz
Dimensions: L: 80mm x H: 52mm x W: 25mm
Weight: 63g (without batteries)
Learns in (pairs) with 3 transmitters
3 Channel pager receiver with LEDs for Sen 1, Sen 2, Sen 3
Volume/vibration select button
Alarm cancel/reset button
Strong belt clip and lanyard attachment clip
Simple transmitter pairing
Status indicator LED: Low battery, active alarm
Alert options: Vibrate only, vibrate and low tone or vibrate and high tone volume
Pager low battery warning and sensor low battery (with compatible transmitters)
Side power On/Off switch